烧成制度对干法造粒制备轻质陶瓷砖性能的影响

2016-01-12 10:03:31张博烨,黄剑锋,陶晓文等
陶瓷 2015年8期

烧成制度对干法造粒制备轻质陶瓷砖性能的影响*

张博烨1黄剑锋1陶晓文2李康1汪庆刚1李转2费杰1闫开放2刘纯2

(1 陕西科技大学材料科学与工程学院西安710021)(2 咸阳陶瓷研究设计院陕西 咸阳712000)

摘要以抛光废渣、高铝泥、恒峰砂、力鸿砂、黑滑石为原料,采用干法造粒工艺,在1100℃~1200℃,保温时间为10~30min条件下,制备轻质陶瓷砖,并研究了烧成制度对轻质陶瓷砖性能的影响。结果表明:随着烧成温度的升高,轻质陶瓷砖线膨胀率逐渐升高;吸水率呈先升高再降低而后升高的趋势,在1170℃时达到最低值;抗折强度和容重随着烧成温度的升高逐渐降低。随着保温时间的延长,试样容重和抗折强度逐渐降低,但变化不明显。烧成温度为1160℃,保温时间为15min时,制备的轻质陶瓷砖抗折强度为6.3MPa,吸水率为2.3%,闭气孔率为71.2%,容重为0.64g/cm3。

关键词干烧成制度干法造粒抛光废渣轻质陶瓷砖

基金项目:*国家科技支撑计划项目(项目编号:2013BAF09B02);陕西省科技厅重点科研创新团队计划项目(项目编号:2013KCT-06)。

作者简介:张博烨(1991-),硕士,实验员;主要从事绿色陶瓷制造的研究。

作者简介:通讯黄剑锋(1970-),教授,博导;主要从事绿色陶瓷制造的研究。

中图分类号:TB321

Effect of Firing Schedule on Preparation of Lightweight Foamed Ceramic Tile by Dry Granulation Process

Zhang Boye1, Huang Jianfeng1, Tao Xiaowen2, Li Kang1, Wang Qinggang1, Li Zhuan2, Fei Jie1, Yan Kaifang2, Liu Chun2(1 Shaanxi University of Science&Technology,School of Materials Science and Engineering,Xi'an,710021)(2 Xianyang Research & Design Institute of Ceramic,Shaanxi,Xianyang,712000)

Abstact:Lightweight ceramic tile was sintered at 1100~1200℃ with 10~30min holding time after granulation process using polishing tile waste, high alumina clay, Hengfeng quartz, Lihong quartz and black talc. Influence of properties of lightweight ceramic tile with different firing schedule was discussed. The results showed: linear expansion ratio of was increased with the increasing sintering temperature, water absorption was increased firstly and then increased again after decreased, reached its minimum value at 1170℃. Bending strength and bulk density were decreased with the increase of sintering temperature. Bulk density and bending strength were decreased not obviously with the prolong of holding time. The lightweight ceramic tile was prepared at 1160℃, 15min, which properties were as follows: bending strength 6.3MPa, water absorption 2.3%, closed porosity 71.2%, bulk density 0.64g/cm3.

Key words:Firing schedule; Dry granulation; Polishing tile waste; Lightweight ceramic tile

前言

近年来,我国陶瓷行业飞速发展,但同时对环境也造成了严重污染。据《2014年全国瓷砖产能报告》统计,2014年全国陶瓷砖年产能达139.6亿m2,其中抛光砖产能占27.9%,是最主要的陶瓷砖产品。陶瓷企业平均每生产1m2的抛光砖,将产生1.5kg的砖屑和0.6kg抛光磨具损耗的碎屑,共计产生2.1kg的抛光废渣。按照浆状废料含水率为35%计,2014年产生的陶瓷抛光废渣超过2300万t。……

登录APP查看全文