电涡流传感器激励信号源设计

2016-01-29 03:52:07孙云
机械制造与自动化 2015年4期

孙云

(南京理工大学 机械工程学院,江苏 南京 210094)

电涡流传感器激励信号源设计

孙云

(南京理工大学 机械工程学院,江苏 南京 210094)

摘要:在电涡流检测系统中,电涡流传感器需正弦信号加以激励。激励信号源是检测系统的关键部分之一。介绍了电涡流传感器信号激励源电路的工作原理,可以给电涡流传感器的并联谐振回路提供稳频稳幅的正弦信号。实验表明,该激励信号源电路能够满足电涡流传感器的需求,使涡流传感器能够稳定地工作。

关键词:电涡流;激励源;正弦信号;信号调理电路

Eddy Current Sensor Excitation Signal Source Design

SUN Yun

(Nanjing University of Science and Technology, Nanjing 210094, China)

Abstract:In eddy current testing system, the eddy current sensor needs to be excited by a sinusoidal signal. The excitation source is one of the key parts in the detection system. The article describes the working principle of the eddy current sensor signal source circuit, which can provide a stable amplitude and frequency of the sinusoidal signal for the eddy current sensor. The experiments result show that the excitation signal source circuit meets the needs of the eddy current sensor. It can make the eddy current sensor operate smoothly.

Keywords:eddy current; excitation source; sinusoidal signal; signal conditioning circuit

0引言

电涡流传感器是一种性能优良、能够测量多种参量的传感器。其工作基于电涡流效应,即在交流信号的激励下,被测参量的变化引起电涡流传感器线圈参数的变化,进而由测量电路转换为电信号,实现对被测参量的测量[1]。

用于动态位移测量的电涡流传感器,一般采用定频调幅式测量电路,其原理如图1所示[2]。图1中,R为匹配电阻、C为匹配电容,电涡流传感器等效为电感L并与C并联组成谐振回路,E为交流激励信号源。空载时回路固有频率与激励信号源频率相同,回路谐振,输出电压U达到峰值。测量位移时,因被测金属物体与电涡流传感器相对距离x的改变,引起传感器等效电感L变化,回路失谐,输出电压U亦发生相应变化,如图2所示。经后续电路处理,即可实现L-x关系与U-x关系的转化,测出位移x[3-4]。

图1 定频调幅电路的工作原理

图2 谐振特性曲线

设图1中激励信……

登录APP查看全文