王金博 王金业 高艳红


摘要:涡轮增压器是一种以内燃机工作所产生的废气为驱动的空气压缩机[1]。涡轮增压器通过增压增加了气缸的进气量,提高燃油效率,增加了发动机的输出功率,改善发动机的性能,因而得到了广泛的应用。本文首先通过三维建模软件SolidWorks建立叶轮模型,然后利用ANSYS Workbench对叶轮进行静力学分析和模态分析。静力学分析得到叶轮最大变形位置及最大变形量;模态分析得到叶轮的各阶固有频率及相应振型。对比增压器的工作时的激振频率与固有频率,避开率较大,不会发生共振。为后续叶轮优化设计提供理论依据。
关键词:增压器;叶轮;ANSYS Workbench;有限元
中图分类号:TNXXXX文献标识码:A
Abstract:Turbocharger is a gas compressor that is used for forcedinduction of an internal combustion engine. Turbocharger has a broad application on the engine because it can improve the performance of an engine by compressing more air into the cylinders, making fuel burn more efficiently and helping the engine generate more power. In this paper, The impeller threedimensional model is established by SolidWorks; Based on the AYSYS Workbench software do research of the impeller on static analysis and modal analysis .Through static analysis, The maximum deformation areas and maximum deformation of the impeller are obtained; Through modal analysis,The natural frequencies and mode shapes of the impeller are obtained.Comparing the excited frequencies and the natural frequencies of the impeller, and the avoid rate is far larger, so does not cause resonance. To provide the theoretical basis for the following optimization design.
Key words:Turbocharger;impeller;ANSYS Workbench;finite element analysis
涡轮增压器是发动机重要的子系统之一,它工作的可靠性、稳定性以及使用寿命对发动机有着重大的影响。转子系统是涡轮增压器的核心部件,它的性能和寿命直接影响着增压器的运转性能。
本文研究的涡轮增压器其工作转速在20004000r/min,在叶轮工作的工程中,增压器除了存在很大的噪声和振动。叶轮在高速旋转时,由于受到自身重力,离心力以及气流的反作用力,了解叶轮在工作过程中受力情况,对后期的设计制造提供参考依据,所以需要对叶轮进行静力学分析。
在正常工作时,由于叶片周围不对称结构以及叶片旋转所形成的周向不均匀流场相互作用,在叶片上作会产生周期性的激振力,当激振力频率与叶轮的固有频率相等或者十分接近时,叶片就会发生共振,会产生剧烈振动,进而可能导致叶轮受到破坏[2]。……