基于三维点云的隧道全局中线提取方法及应用*

2017-10-14 02:42:18程云建仇文革雷劲
湖南大学学报(自然科学版) 2017年9期

程云建,仇文革,雷劲

(1.西南交通大学 交通隧道工程教育部重点实验室,四川 成都 610031; 2.西南交通大学 土木工程学院,四川 成都 610031)

基于三维点云的隧道全局中线提取方法及应用*

程云建1,2†,仇文革1,2,雷劲1,2

(1.西南交通大学 交通隧道工程教育部重点实验室,四川 成都 610031; 2.西南交通大学 土木工程学院,四川 成都 610031)

提取隧道横断面通常是基于隧道中线,而隧道中线提取是最困难的一个环节.本文提出了一种有效的隧道全局中线自动提取算法:通过从隧道的点云水平投影中提取边界点,并利用随机采样一致性算法提取边界点中用于多模型拟合的内点,最终的隧道中线基于再次随机采样的全局优化算法确定.所提出的算法被应用于位于四川的写字岩隧道,结果表明:全局中线提取达到了较高的精度,其均方根误差为16.5 mm;与全站仪测量的隧道中线点相比,偏差的均方根误差为10.3 mm.

隧道工程;中线提取;三维点云;随机采样一致性算法

Abstract:Terrestrial laser scanning has been widely used in tunnel engineering,the extraction of tunnel cross sections is often based on tunnel centerlines,which is the most difficult part.A novel method for automated extraction of tunnel centerlines was presented in this paper.In this process,the boundary points of a tunnel are extracted from tunnel point clouds,the inliers for multiple model fitting are estimated from tunnel boundary points using RANSAC (RANdomSAmple Consensus) algorithm,the final centerlines are determined using a global optimization based on a re-sampled algorithm.The proposed method was applied in the Xieziyan tunnel in Sichuan.The results of application showed the extraction of tunnel centerlines achieved a high accuracy.The RSME of centerlines fitting was 16.5mm.Compared with total station surveying,the RMSE of the deviations was 10.3 mm.

Keywords:tunnel engineering;extraction of centerlines;3D point clouds;RANSAC algorithm

随着高铁隧道修建,隧道安全问题也越来越受到了隧道运营管理者的关注,但是隧道内部通常处于无光的环境中,这势必对隧道测量带来诸多的困难.三维激光扫描技术即使在无光的条件下也能提供高精度、高密度的快速测量[1].所以三维激光扫描仪在隧道检测和变形分析中的应用日益增多[2-6].

隧道中线对于从三维点云中提取隧道横断面十分重要,诸多基于三维激光扫描技术提取横断面的研究[7-11]中都预先提取了……

登录APP查看全文