一种基于迟滞比较器的锯齿波产生电路

2018-03-07 05:24:16魏荷坪孙江陈向东
现代电子技术 2018年4期

魏荷坪+孙江+陈向东

摘 要: 介绍一种基于TSMC 0.18 μm工艺设计的锯齿波产生电路。传统锯齿波产生电路通常以比较器为核心结构,采用恒流源充放电技术实现。为了获得更快的响应速度,设计了一款利用内部正反馈原理实现的迟滞比较器来取代传统比较器,同时改进架构,得到一种对电源电压变化不敏感,具有较高频率的锯齿波产生电路。最终通过HSpice对电路进行了仿真验证,在常温下锯齿波的频率大约为7.5 MHz;同时当电源电压在2.5~4.5 V内变化时,锯齿波的频率变化不超过0.12 MHz。

关键词: 锯齿波; 迟滞比较器; 正反馈; 恒流源; 快速响应; 仿真验证

中图分类号: TN423?34 文献标识码: A 文章编号: 1004?373X(2018)04?0070?05

Abstract: A sawtooth wave generation circuit designed with TSMC 0.18 μm process is introduced. The traditional sawtooth wave generation circuit often takes the comparator as its core structure and is realized with the constant current source charging?discharging technology. To obtain faster response, a hysteresis comparator based on the internal positive feedback principle is designed to take place of the traditional comparator. The architecture is improved to obtain a high frequency sawtooth wave generation circuit insensitive to power supply voltage changes. The circuit was simulated and verified by HSPICE. The results show that the frequency of sawtooth wave at room temperature is about 7.5 MHz, and the frequency change is not more than 0.12 MHz when the power supply voltage changes from 2.5 V to 4.5 V.

Keywords: sawtooth wave; hysteresis comparator; positive feedback; constant current source; quick response; simulation verification

在现代产品中,PWM信号产生电路广泛地应用于开关电源、马达驱动和LED驱动电路中[1]。而锯齿波产生电路作为PWM信号产生电路的前级电路,大范围地应用于现代产品解决方案中,整个电路的性能强烈地依赖于锯齿波发生器的电路性能。在传统的解决方案中,采用普通比较器和带隙基准源产生对电源电压变化和温度变化不敏感的锯齿波。由于受制普通比较器响应时间的限制,较高频率锯齿波的产生成为设计难点。同时设计基准电压源需要占用较大芯片面积,从而不可避免地导致芯片成本的上升。因此设计一种简洁、具有较高频率,对电源电压和温度变化不敏感的锯齿波产生电路已经迫在眉睫。本文将分析锯齿波产生电路的设计原理和基于TSMC 0.18 μm工艺的具体电路实现。

1 锯齿波产生的原理及其改进结构

登录APP查看全文