千鑫
摘 要:施工现场中缺少大型机加工设备时,需要在工件上进行偏心扩孔通常采用两种方式:一种为火焰切孔,另一种为磁力钻钻孔。目前在施工现场扩孔方面没有专用的偏心扩孔钻夹具,也多采用传统方式解决偏心扩孔问题,以往的施工方式存在加工精度低、效率低、扩孔次品率高、大厚度工件无法切削等缺陷,为解决上述存在的问题,发明了一种偏心扩孔装置,该装置具有加工精度高、偏心量可调、车削阻力小、效率高、车削量可调、行程可调等优点,具有较高的推广性和实用性,也为在施工现场遇到同类型的缺陷提供了借鉴方法。
关键词:偏心;扩孔;车削;精度
中图分类号:TG713 文献标志码:A 文章编号:2095-2945(2018)30-0036-03
Abstract: In view of the lack of large-scale machining equipment in the construction site, the eccentric hole reaming is usually carried out in two ways: one is flame hole cutting, the other is magnetic drill hole. At present, there is no special jig for eccentric hole reaming in the construction site, and more traditional ways are used to solve the eccentric hole reaming problem. In order to solve the problems mentioned above, an eccentric hole reaming device was invented to solve the problems in the past construction methods, such as low machining precision, low efficiency, high rate of defective products from reaming holes, and unmachined workpieces of large thickness. The device has the advantages of high machining precision, adjustable eccentricity, low turning resistance, high efficiency, adjustable turning amount, adjustable stroke, etc. It has high popularization and practicability, and provides reference method for the same kind of defects encountered in the construction site.
Keywords: eccentricity; hole reaming; turning; accuracy
前言
某电站设计安装有4台225MW相同型号的水轮发电机组,因此电站采购一套顶盖、底环备件在每台机组扩大性大修期间进行更换,拆除下来的设备进行修复后在下台机组扩大性大修期间进行使用,按照此种方式进行轮换使用,降低生产成本,该电站顶盖设计直径6030mm,重60.7T,共140颗M48把合螺栓,基材分两层,每层厚度100mm,底环设计直径5856mm,重36.7T,共70颗M48把合螺栓,24颗M85把合螺栓,基材厚度273mm,但在某台机组大修期间进行頂盖、底环预装时发现底环有32颗螺栓成不规则偏孔现象,顶盖有50颗螺栓孔成不规则偏孔现象。
在工件上进行偏心扩孔时,通常采用两种方式:火焰切孔和磁力钻钻孔。其中,火焰切孔精度较低,当精度要求不高时,火焰切孔具有较高的切孔效率。而磁力钻的钻孔精度相对较高。……