刘晓阳 许迪 金蓓蓓



摘 要:在宇航领域微波组件射频同轴电连接器与微带板间的互连工艺中,金带连接作为一种较新的互连方式,兼具焊料硬连接和Ω型跨接片焊接的优点。本文通过有限元模拟的方法,建立金带包覆焊接模型,计算在不同金带规格及位置对结构热应力的影响。结果表明,各组金带规格、包覆位置在不同温度载荷条件下金带上的最大等效应力值都很低,各组数据都远低于金带的拉断强度。金带包焊通过柔性连接的方式可有效抵消热失配产生的材料内部应力。
关键词:有限元仿真;金带连接;电阻焊;射频同轴电连接器
Abstract:In the interconnection process between the microwave component RF coaxial electrical connector and the microstrip board in the aerospace field,the gold strip connection has the advantages of solder hard connection and Ω-type jumper welding as a relatively new interconnection method. In this paper,the finite element simulation method is used to establish the model of gold strip cladding welding,and the influence of different specifications and positions of gold strip on the heat stress of structure is calculated. The results show that the maximum equivalent stress values of each group of gold strips are very low under different temperature loading conditions,and the data of each group are far lower than the tensile strength of gold strips. Through flexible connection,the metal strip cladding welding can effectively offset the internal stress caused by thermal mismatch.
Keywords:finite element simulation;gold strip connection;resistance welding;RF coaxial electrical connector
0 引 言
射頻同轴电连接器是宇航微波领域重要的射频传输元件,广泛应用于微波通信[1,2]。随着微波信号频段的不断提升,宇航领域微波产品的频段已覆盖到X以及Ka波段,对信号传输部分的损耗及电压驻波比也有了更高的要求。射频同轴电连接器与微带板之间的连接方式通常有焊料硬连接和Ω型跨接片(可伐镀金或铜带)焊接、金带连接三种方式。传统的直接焊接信号差损小,驻波较好,但由于常用铝基壳体与陶瓷微带板的热膨胀系数不匹配导致焊点内部在热循环条件下会产生较大的热应力,存在较高风险;Ω型跨接片的焊接方式利于释放热应力,但在2 GHz以上的频段会大大增加信号差损,恶化驻波比,同时由于跨接片尺寸较小,手工焊接难以保证焊接质量;金带连接是通过电阻点焊的方……