程宇阳
摘 要
本文介绍了秦山三厂除氧器液位控制的三冲量原理和实现方式,讨论了由于控制器异常导致除氧器高液位隔离的过程并对其原因进行了分析。总结出除当氧器液位异常时的一般处理过程,并提出了自己的改进措施。
关键词
除氧器液位; PID三冲量控制;原因分析;应对措施
中图分类号: TM623 文献标识码: A
DOI:10.19694/j.cnki.issn2095-2457 . 2020 . 17 . 81
Abstract
This paper introduces the principle and the way to achieve of the three-impulse control of PID for the deaerator level control in the Third Qinshan plant. Its also discussed the process of the isolation for the high level of the deaerator. The reason which causes, meanwhile, is analyzed too. Finally, the article is to sum up the usual process when the deaertor level is abnormal and puts forward some measures to improve its own.
Key words
The deaerator level; Three-impulse control of PID; Reason analysis; Countermeasures
0 概述
(1)除氧器功能簡介
除氧器是电厂二回路连接凝结水系统和给水系统的重要设备,由除氧水箱和除氧头组成。除氧器的主要作用是除去给水中的氧气及其他不凝结性气体,保证给水的品质,减少腐蚀,提高传热效率。同时,除氧器本身又是给水加热系统中的一个混合式加热器,起到加热给水,提高给水温度的作用。
我厂除氧器为直接接触水平盘型,带一个独立分离的水平储水箱,位于汽轮机厂房第5层,在正常液位时,水箱的容量为338m3,可满足电厂满功率运行5分钟的需水量。
(2)除氧器液位控制器控制原理分析
我厂除氧器液位控制采用的是三冲量、内部串级加前馈控制方式。
除氧器液位控制的三冲量分别是 :输入一(IN1)为凝结水流量,输入三(IN3)为给水流量,输入五(IN5)为除氧器液位。
内部串级:每个控制器内部设定有两个回路(LOOP1/LOOP2),LOOP2为主回路用于液位控制,LOOP1为副回路用于凝结水流量调节,主、副回路是串联作用的,LOOP2的输出作为LOOP1的设定点。控制器64321-LC4410A/B/C两个回路都在同一界面显示,左边的是液位回路,右边的是流量回路,改变设定值只能改变液位的设定值,流量的设定值通过液位计算得出,无法手动修改。……