唐妍 付维洁 张毅









摘要: 对空心工业铝材进行热锻挤压模具设计和3D造型,基于DEFORM软件对挤压过程进行数值模拟。模具设计时优化分流孔入口形状并提出金属流速判据。通过分析模拟结果,采用调整模具工作带长度的方法,改善挤压模出口流速的均匀性,保证了型材质量,有效减少模具开发周期和成本,达到试模、修模的快速响应。
Abstract: The hot forging extrusion die design and 3D modeling of hollow industrial aluminum materials are carried out, and the extrusion process is numerically simulated based on DEFORM software. In the mold design, the inlet shape of the shunt hole was optimized and the metal flow rate criterion was proposed. By analyzing the simulation results, the method of adjusting the length of the die working belt is adopted to improve the uniformity of the exit flow rate of the extrusion die, ensure the quality of the profile, effectively reduce the mold development cycle and cost, and achieve rapid response to mold trial and mold repair.
关键词: 分流孔;速度分布;数值模拟;模具结构优化
Key words: diversion hole;velocity distribution;numerical simulation;mold structure optimization
中圖分类号:TG162.41 文献标识码:A 文章编号:1674-957X(2021)17-0096-03
0 引言
工业铝材作为一种耗能少、可塑性强和较强的耐腐蚀性的轻质金属,在航空航天、建筑、汽车等工业领域被广泛使用,特别是近几年来汽车行业的快速发展,工业铝材由于其操作方便,稳固牢靠,易安装和拆卸,不生锈易保养等优点,可广泛应用于汽车检修支架,汽车测试支架,汽车喷漆灯架,汽车框架展示架,汽车驾驶模拟测试架等产品的应用。由于铝材特别是空心铝材的成形模具结构复杂,导致模具企业开发、制造的周期较长,同时试模、修模阶段也具有较高难度[1-3]。利用基于DEFORM的有限元模拟软件对铝材热锻挤压过程中的速度场等进行数值模拟,能够快速调整模具工作带长度,成为快速优化模具结构,降低生产成本,缩短模具开发周期的有效手段。
1 建立型材成型模具模型
1.1 热锻挤压模设计
本文以某Al6063工业铝材为例,尺寸规格φ=L/D=101.2/44.5≈2.28,壁厚t=1.7mm,热挤压过程中挤压比λ=46.3,产品尺寸如图1所示。
考虑企业生产实际,本产品需采用平面分流挤压模进行成形生产,根据挤压模具设计原则,利用Pro/E软件设计其成形热锻模上、下模。……