黄晓阳



摘 要:石油化工园区污水处理厂的前期设计一般会考虑后期的最大处理能力。随着负荷的不断增大,实际处理能力也在不断提高,但是,由于较大的设计容量和处理能力与现阶段不饱和的处理量存在一定的矛盾,无论是经济上还是技术上都存在一定的不匹配度,所以针对较大的设计容量和较低的实际运行负荷问题,合理化的运维管理是污水处理厂规范运转的关键所在。泉惠石化工业区园区项目采用了改良型的A/O工艺,对高负荷设计的园区污水处理厂进行了低负荷的运维管理,在减小运行成本的同时得到了较为稳定的出水水质。
关键词:污水处理;总氮;化学需氧量;总磷
中图分类号:X703.1文献标识码:A文章编号:1003-5168(2021)16-0053-04
Abstract: The maximum treatment capacity in the later stage is generally considered in the preliminary design of the sewage treatment plant in the petrochemical park. With the continuous increase of load, the actual processing capacity is also improving. However, due to the contradiction between the large design capacity and processing capacity and the unsaturated processing capacity at this stage, there is a certain mismatch in economy and technology, so for the problem of large design capacity and low actual operation load, Reasonable operation and maintenance management is the key to the standardized operation of sewage treatment plant. The improved A/O process is adopted in the park project of Quanhui petrochemical industrial zone to carry out low-load operation and maintenance management for the sewage treatment plant in the park with high load design, so as to reduce the operation cost and obtain relatively stable effluent quality at the same time.
Keywords: sewage treatment;total nitrogen;chemical oxygen demand;total phosphorus
调查研究表明,石油化工园区污水处理厂在设计规模、总体工艺路线、相关参数设定、实际处理能力等方面都存在诸多问题,其中较为突出的问题是运行负荷只有设计能力的50%左右[1]。石油化工园区污水处理厂来水的水质水量变化大,成分复杂,并且脱氮除磷的处理工艺选择难度更大,在进行工艺设计时,应充分考虑外部能源的介入问题,以降低处理成本。某工业园区污水处理厂进行了前置预缺氧、多点进水的改良型两级A/O(Anoxic Oxic)脱氮除磷工艺的优化设计,避免了传统A/O工艺中脱氮和除磷相互竞争碳源的问题,并合理降低了硝酸盐对厌氧释磷的影响,碳、氮、磷去除率得到了同步提升[2]。污水厂通过优化工艺,出水水质达到《城镇污水处理厂污染物排放标准》(GB 18918—2002)的一级B标准[3]。……