梅花井煤矿232205工作面运输巷探放水技术

2021-11-28 04:29:09孟永华李立波史春黄辉黄海鹏
河南科技 2021年14期

孟永华 李立波 史春 黄辉 黄海鹏

摘 要:为提高掘进巷道安全保障能力,以232205工作面运输巷掘进为研究对象,针对顶板含水层涌水给巷道掘进带来的影响,提出布置超前探放水钻孔对含水層进行疏排。依据巷道掘进实际情况,对超前探放水钻孔设计、施工及探放水情况进行分析。现场应用后,232205工作面运输巷掘进期间仅有局部位置出现顶板淋水,淋水量控制在0.3 m3/h以内,其余位置均未出现淋水情况;通过超前探放水,为巷道掘进及围岩支护创造了良好条件。

关键词:巷道;含水层;疏排水;探放水钻孔

中图分类号:TD353文献标识码:A文章编号:1003-5168(2021)14-0071-03

Abstract: In order to improve the safety guarantee ability of tunneling roadway, taking the tunneling of 232205 working face as the research object, in view of the influence of water gushing from the roof aquifer on the tunneling, an advanced exploration and drainage borehole was proposed to drain the aquifer. According to the actual situation of roadway excavation, the design, construction and water exploration and drainage of advanced drilling holes are analyzed. After field application, during the driving of transportation roadway on 232205 working face, only partial roof water drenching occurred, and the water amount was controlled within 0.3m3/h, and no water drenching occurred at other positions. It creates good conditions for roadway excavation and surrounding rock support through advance exploration and drainage.

Keywords: tunnel;aquifer;hydrophobic drainage;drilling hole for water exploration and drainage

1 工程概况

232205工作面为23采区2及2-2煤第三个回采工作面。232205工作面运输巷设计沿45°40′方位掘进,巷道设计走向长2 667 m。掘进区域内区2及2-2煤厚约4.56 m。煤层顶板以粉砂岩为主,底板岩性以细砂岩为主。运输巷采用综掘方式掘进,断面为直墙半圆拱形,掘进面积为21.33 m2,净断面积为19.79 m2。

2 巷道掘进区域水文条件及水害分析

2.1 涌水水源

巷道掘进区域内涌水水源有地表水、顶底板含水层两种[1-2]。

工作面埋深约650 m,对应的地表水主要受大气降水影响,现阶段地表水对232205工作面运输巷基本无影响。

232205工作面运输巷顶板含水层为直罗组粗砂岩含水层,岩性主要为中、粗粒砂岩位置夹少量的粉砂岩和泥岩;底部为含砾石英长石粗砂岩,松散~较松散,弱胶结,含水层涌水量为1.09 L/s,渗透系数K=0.13 m/d。工作面沿掘进方向距顶板含水层层间距为0.00~7.36 m,含水层厚度为18.84~50.32 m。

2及2-2煤厚上覆有粉砂岩直接顶做隔水层,但局部原生裂隙、掘进次生裂隙、掘进中锚杆锚索支护会导致老顶粗砂岩含水层的水导入巷道,造成突水。……

登录APP查看全文